Carwiner 2pcs Screen Protector Compatible With 2021-2023 Mustang Mach-E, 15.5 Inch Navigation + 10.2

Carwiner 2PCS Screen Protector Compatible with 2021-2023 Mustang Mach-E, 15.5 Inch Navigation + 10.2 Inch Dashboard Set, Center Control Tempered Glass Accessories (HD)

• [PERFECT FIT FOR]: Tempered glass HD screen protector 2PCS compatible with the 2021 2022 2023 Ford Mustang Mach-E 15.5 inch navigation + 10.2 inch dashboard touchscreen.
• [Laser Cutting and Precise Fit] Laser cutting. After many adjustments, the size has been adjusted to the most perfect.
• [FINGERPRINT RESISTANT]: You don’t have to wipe your screen with a rag every day. The screen protector layered with an oleophobic coating that repels oil left from your fingerprints and adds an additional smoothness to the navigating screen.
• [9H HARDNESS]: The tempered glass screen protector has a thickness of only 0.3 mm and a surface hardness of 9H, while the surface hardness of ordinary PET film does not exceed 3H.
• [EASY INSTALLATION]: Align the protector with your screen, then install it with the provided accessories that makes the installation easy. Installation is similar to cellphone screen protectors, just take couple of minutes to finish.

Buy Now : Carwiner 2PCS Screen Protector Compatible with 2021-2023 Mustang Mach-E, 15.5 Inch Navigation + 10.2 Inch Dashboard Set, Center Control Tempered Glass Accessories (HD)

Brand : Carwiner
Category : Electronics,GPS, Finders & Accessories,GPS System Accessories,Screen Protector Foils
Rating : 4.6
ListPrice : US $29.99
Price : US $25.99
Review Count : 92
ChildASIN : B09QQ7PC4Z,B09QQ9YXMS

Carwiner 2PCS Screen Protector Compatible with 2021-2023 Mustang Mach-E, 15.5 Inch Navigation + 10.2 Inch Dashboard Set, Center Control Tempered Glass Accessories (HD)

• Take the time to clean and link remove the large screen and use painter\'s tape to dry align the screen before removing the plastic from the adhesive to get your alignment perfect around the dial. I had a couple of bubbles but was able to work them out with a cloth. One stubborn spot near the edge was fixed with 30 seconds of heat from a hair dryer and then 30 seconds of light pressure with a cloth, a month after installing no bubbles, no glare, and very happy with the product!
• Overall, installation was simple enough, like applying to a phone screen. That being said, the cut for the main screen could definitely use some work.If I was applying this to my phone screen I probably would have taken it off and throw it in trash and buy another brand. But since I\'m not looking at it often... It good enough for now.
• really easy to install and it is a perfect fit
• I was initially concerned about lack of instructions in the package but upon removing the screen protector from its pouch, you can see a tag on each indicating the back side that needs to be peeled off for installation. The rest is common sense and patience. Wipe the car screens good to remove any dust and finger prints, remove the back film of screen protector holding by the corner so you don’t touch the sticky part, align the corners with car screens and voila! You may need to pull out some corners and re-apply gently to get rid of some stubborn bubbles that can’t be removed with the bubble removal card.
• Worked perfectly
• The kit is nice, they provide the proper cleansers, squiggee etc.HOWEVER!the front small screen, it\'s too small, There is no reason for the fitment to be that small, plenty of room, unless it was cost cutting, allowed to get 2-4 pieces out of a single piece of stock, but not happy about that. Fitment could be betterMain screen, same, a tad short, and could be slightly wider for more coverage. Maybe they did this to give someone some room, in case their instal was not perfect, however the other side of that coin is if they made it the perfect size, there would be no question on how it should be installed.So a rating of 3, quality seems there, but I\'m not happy about the size and wish it really was \"for the Mach-E\". vs well it\'ll fit, that\'s all we care about.
• Easy to install. I bought two, first I tried the matte but it made the screen look blurry so then I tried the HD version and it looks better. I have issues with it though. First the knob cutout is not centered even though I have it perfectly centered in the display. Second, there is a small part of the bottom right corner that doesn’t fully stick. I will keep it on for now but I will probably replace it with a different brand eventually
• Screen protectors fit well. I have had them installed for a few weeks now and have not had any issues. It was a bit of a pain to install the larger one centered on the volume knob, but this is not a product issue, just a heads up.

Location:

Share :